You’ll need a screwdriver and a wrench to install the DripStop® Valve. (NOTE: Make sure you turn off the water supply before you begin).

1. Disassemble the Faucet

Using the wrench, remove the stem assembly from the faucet you might want to cover the retaining nut – that’s the nut that holds the stem assembly in place – with a thin towel to protect it from being marred by the teeth of the wrench).

2. Remove the Old Washer

Using the screwdriver, remove the old-fashioned rubber washer from the end of the stem.

3. Install the DripStop® Valve

Screw the DripStop® Valve into the exact place on the faucet stem where you took out the old washer.

4. Reassemble the Faucet

Replace the stem assembly and tighten with the wrench.


If you find that none of the answers provided here satisfactorily resolves the issue you are having, call Customer Service at (775) 747-3340.